Main Forum > Artists Corner

How can I do this?


I have a Mame control panel I'm making. My idea is I'm going to print out 2 pages as an overlay, then put plexiglass, or Lexan over that. I want to design my own thing, but I want it to line up- be in proportion. As my panel is bigger than a sheet of paper, I'm using 2 sheets and putting them together. The size of my control panel is 7.25 inches high, by 21.00 inches wide. I want to put "FIRE" etc on there, but I want it to line up with my buttons. I have not cut any holes yet, I want to use this design as a template to cut my holes.


[0] Message Index

Go to full version